Urine Hose for Separett – 2 metres 11131-01

Suitable for use where the original hose has become damaged and you need a replacement. Can be used to extend the urine hose – you’ll also need a straight or right-angle connector to join it onto an existing piece of Separett hose (not included – please see below for links to these on our webshop). The hose can be used to create gentle curves and bends, but sharp bends may cause the hose to buckle and block.

If you need a longer run, you might want to consider using rigid pipework to ensure no ‘sagging’ occurs over the length and drop of the pipe (which will trap urine and potentially calcify over time). Please see our article on using standard pipework here:
https://www.waterlesstoilets.co.uk/2024/05/27/using-standard-32mm-rigid-pipes-on-separett-toilets-for-urine-diversion/

For long runs outside, or where sub-zero temperatures are expected, it’s recommended that you use 40mm or 50mm rigid pipework as this will stay clear of blockages etc due to freezing.

Specifications

• Approximate length 2 metres.
• 32m outer diameter.
• Suitable for all models of the Separett Villa and Tiny with urine extraction.
• Pipe must be supported at regular intervals (if run horizontally) at regular intervals
• Ensure a drop of around 1 in 10 on horizontal runs

Other useful items:

Straight connector (to join two pieces of this semi-flexible pipework to each other):
https://www.waterlesstoilets.co.uk/toilets/urine-pipe-connector-32mm-straight/

Angled connector (to join two pieces of this semi-flexible pipework and create a 90º bend):
https://www.waterlesstoilets.co.uk/toilets/urine-pipe-connector-32mm-90-degree-angle/

Urine trap (when running urine into an existing greywater drain – creates an odour trap to stop smells coming back up the pipe):
https://www.waterlesstoilets.co.uk/toilets/waterseal-urine-waste-pipe-trap/